20 September 2017

Service Bulletin - Installation of Drawbar Pins

An important service bulletin regarding the installation of Drawbar Pins WT1202D-69315.

 

Introduction:

We recently came across an incident involving a drawbar pin similar in design to but not the WT1202D-69315, in which the washer had been worn off. When looking at the pictures from this incident, it was apparent that the nut had been tightened as wear appeared without recourse to finding out where that wear had taken place.

When asking general questions around this incident it became clear that there are a number of different ways people install these pins. Due to this, we have decided to refresh our Installation and Maintenance procedures.

Click here to view the bulletin.